Unfold the NavVis VLX
Use the belt hook to unfold the NavVis VLX.
Caution: Keep your fingers and clothes clear of the folding mechanism.
Secure the folding mechanism
Tighten two locking screws shown with the torque wrench, until you hear a click (2.5 Nm). The NavVis VLX must rest in the box during this step.
Insert the SSD
Insert the SSD into the slot on the side of the NavVis VLX.
Insert the batteries
Insert the batteries into both mounts and ensure they are fully locked into position (you will hear a click).
Remove from the box
Grasp the handle and frame, and remove the NavVis VLX from the box.
Place on a level surface
Place the NavVis VLX on a flat level surface such as a table or the floor. The belt hook and shoulder hooks must rest on the surface.
Clean the sensors
Use a clean and dry microfiber cloth from the shipping box to clean the cameras, laser scanner and screen gently.
Clean the cameras.
Clean the laser scanners.
Clean the screen
Switch on the NavVis VLX
Press the power button on the side of the NavVis VLX. Leave the device on a flat surface for 30 seconds until the device is ready (indicated with a beep).
Remove the plastic film cover from the screen.
FAQ
How do I unfold the NavVis VLX?
Use the handle to unfold the NavVis VLX, ensuring to keep your fingers and clothes clear of the folding mechanism.
What should I do after unfolding the NavVis VLX?
Secure the folding mechanism by tightening two locking screws with a torque wrench until you hear a click (2.5 Nm). The device must rest in the box during this step.
Where do I insert the SSD?
Insert the SSD into the slot on the side of the NavVis VLX.
How do I insert the batteries?
Insert the batteries into both mounts and ensure they are fully locked into position; you will hear a click when they are secure.
What is the proper way to remove the NavVis VLX from the box?
Grasp the handle and frame, and carefully remove the NavVis VLX from the box.
Where should I place the NavVis VLX?
Place the NavVis VLX on a flat level surface such as a table or the floor, ensuring the belt hook and shoulder hooks rest on the surface.
How do I clean the sensors?
Use a clean and dry microfiber cloth to gently clean any dust or fingerprints from the cameras or laser scanners.
How do I switch on the NavVis VLX?
Press the power button on the side of the NavVis VLX and leave it on a flat surface for 30 seconds until it is ready, indicated by a beep.