Prerequisite
Ensure that the NavVis MLX has been setup correctly, refer to the documentation in the Shipping Case or here.
Procedure
Make sure the device is placed on a level surface such as the ground or a table.
Open the Back Cover and press the On/Off Button to power on.
.PNG?sv=2022-11-02&spr=https&st=2025-04-19T05%3A44%3A54Z&se=2025-04-19T05%3A55%3A54Z&sr=c&sp=r&sig=3bHcTqCr8q6EeCUJw3hiLrFSrGepXKDZEW29EpTxhlk%3D)
Caution: Do not move the device during this step, this is because the inertial sensors inside the device are calibrating, and they are very sensitive to movement. If it is moved during startup, the screen will indicate the need for another calibration.
.PNG?sv=2022-11-02&spr=https&st=2025-04-19T05%3A44%3A54Z&se=2025-04-19T05%3A55%3A54Z&sr=c&sp=r&sig=3bHcTqCr8q6EeCUJw3hiLrFSrGepXKDZEW29EpTxhlk%3D)
The NavVis system software launches automatically after the system initializes.
If this is the first time powering on the device, accept the license.
The screen will display the Home Screen and the device is ready for scanning.
FAQs
What should I do before powering on the NavVis MLX?
Ensure that the device has been set up correctly by following the instructions provided in the documentation found in the Shipping Case or available online.
Where should I place the NavVis MLX before starting it?
Place the device on a level and stable surface, such as the ground or a sturdy table, to ensure accurate calibration.
How do I power on the NavVis MLX?
Open the Back Cover of the device.
Press the On/Off button to start the device.
Wait for the system to initialize automatically.
Can I move the device while it’s starting up?
No. Do not move the device during startup. The inertial sensors inside are calibrating, and even minor movement can cause calibration errors. If movement is detected, the screen will prompt you to restart the calibration process.
What happens after the device initializes?
The NavVis system software will launch automatically. If it’s your first time starting the device, you’ll be asked to accept the license agreement.
How will I know when the device is ready for scanning?
Once the system has fully booted, the Home Screen will appear, indicating the device is ready for scanning.
What if I see a calibration warning on the screen?
If the device was moved during startup, the inertial sensors may not calibrate properly. Simply restart the device on a stable surface and avoid movement during initialization.