Checking and Charging the Li-Ion Batteries
  • 15 Nov 2024
  • 1 Minute to read
  • Dark
    Light
  • PDF

Checking and Charging the Li-Ion Batteries

  • Dark
    Light
  • PDF

Article summary

Only use Li-Ion Batteries designed for use with the device and approved by NavVis.

  1. Check the Li-Ion Battery level

Press the button on both the supplied Li-Ion Batteries to check if they need charging. You need at least 51-75 % full to begin scanning (3 of the 4 lights on).

The LEDs on the Li-Ion Battery indicate different levels of charge:

  1. Assemble the Battery Charger

Insert the Battery Power Cable to the Battery Charger.

Insert the Li-Ion battery, make sure it is fully inserted.

Connect the Battery Power Cable to an appropriate power source:

  • The LED indicator on the Battery Charger will turn red as it is charging and green once the Li-Ion Battery is fully charged.

  • Disconnect the Li-Ion Battery once charging is complete.

  • Dispose of the Li-Ion Batteries properly in compliance with local regulations Contact NavVis Support for instructions on the correct recycling procedure.


Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.