Scanning with Control Points

Note: You can capture a control point more than once within a Dataset if it is passed multiple times during mapping.

Note: If the control point is not saved within 60 seconds it must be set again.

Procedure

1. Press the control point button in the user interface to activate the downward-pointing laser cross of the NavVis M6.

2. Move the laser cross exactly over the cross on the marker. The centers of the crosses must line up, but the orientation does not matter.

   

3. In the Set a control point screen, press Set control point. This sets the current device position as a control point.

4. In the next Set a control point screen, enter a control point ID in the field provided. The ID you enter must match the ID on the control point marker.

5. Press SAVE to confirm, or Retry to undo or repeat a measurement before the control point is saved. If the control point is not saved within 60 seconds, it must be set again.