Hardware Setup Instructions

This section contains information on how to set up the hardware of the NavVis VLX. Caution : Do not attempt to dismantle or repair your NavVis VLX. Refer here for support information. Caution : Do not remove the NavVis VLX from...

Note: To begin scanning make sure at least two batteries are at 80% full (4 out of 5 LED indicators on). Check the battery level Press the button on the side of the battery to check if the battery needs charging. Each LED indicates 20% of ...

Note: This step should only be performed if the size needs adjusting. Remove the screws With the NavVis VLX in the box, remove the two screws with the torque wrench provided. Adjust the size Slide the belt hook to the correct size...

Unfold the NavVis VLX Use the handle to unfold the NavVis VLX. Caution : Keep your fingers and clothes clear of the folding mechanism. Secure the folding mechanism Tighten two locking screws shown with the torque wrench, until yo...

Putting on the belt Fasten the belt tightly around your waist. The hook holster must face forward. The straps must not be twisted. Note: If required remove the back pad for a tighter fit or add the belt extension for a wider fit (provided i...