Correcting a wrong selection of belt hook size before processing
  • 16 Feb 2024
  • 1 Minute to read
  • Dark
    Light
  • PDF

Correcting a wrong selection of belt hook size before processing

  • Dark
    Light
  • PDF

Article summary

Introduction

Problem description

If you have selected a belt size in the UI of the NavVis VLX screen and proceeded to scan only to realize the wrong belt setting was selected, this can be corrected. No rescans are required.

Note: This error must be corrected before post-processing.

Scope

This procedure only applies to NavVis VLX 1 and 2. Belt selection in the NavVis VLX3 is automatic.

Troubleshooting procedure

  1. Go to the datasets_rec folder. 

  2. Select the specific dataset folder.

  3. Open the file sensor_frame_dynamic.json with a standard text editor.

  4. Change the belt size in the file to the one which you have actually used during scanning.

  5. Change the code "hook": {"size": "XL"}

  6. Save the file and continue with processing as usual.


Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.