Calibrating the Device
  • 12 Sep 2024
  • 1 Minute to read
  • Dark
    Light
  • PDF

Calibrating the Device

  • Dark
    Light
  • PDF

Article summary

The NavVis MLX automatically calibrates when powered on, however if there is an error with the initial calibration then the manual calibration screen will be displayed.

The calibration is an important step to achieving accurate scans. If the calibration fails again, reboot the device.

caution(1)Caution: Do not move the device during this procedure. If the device is moved during this step, point cloud quality may be significantly reduced.

  1. Tap Calibrate.


  2. Wait for the progress bar to reach 100%. This should take about 20 seconds. If you want to cancel the calibration, tap Cancel.

  3. The screen displays a message indicating that the calibration is successful.


Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.